problem at work....

[fliszt]

Hi,

i have a problem with a machine which im calibrating:

the Basic Machine constants for the Transmission Image Sensor is NOT OK!!!

i get the warning that the Shift between order drift exceeds the warning level of 100nm and that the Electrical signal of flow sensor at Right Exhaust manifold is too low......WHAT TO DO?

[thalbergmad]

I would love to help, but i have not the faintest idea to what you are referring to.

Sounds a bit complex.

Thal

[fliszt]

hmmm i think i go take a break...that usually helps

[thalbergmad]

Usually works for me old chap.

Thal

[term]

i get the warning that the Shift between order drift exceeds the warning level of 100nm and that the Electrical signal of flow sensor at Right Exhaust manifold is too low......WHAT TO DO?

Throw it out of the window.

[fliszt]

now that sounds like a nice plan....only it weights about 7000kg...

[ramithediv]

Turn it off, wait 5 mins, and turn it back on again. 

I should have been an I.T. consultant. 

[fliszt]

hmm done that...
now it says:

system warning: FM-021C DEFAULT
odf data mismatch for component [MO_RS]
[MO-RS]
Location = mpcr/vme:mhb@slot10/hssl.2:MPAC@0
odf file: ODF/MO63400766_01_160_901_adjustment-instructions.txt
dpf status domo block[1] = under_development
ODF FILE IS NOT VALID FOR THIS LOCATION


good luck with that one

[ramithediv]

system warning: FM-021C DEFAULT
odf data mismatch for component [MO_RS]
[MO-RS]
Location = mpcr/vme:mhb@slot10/hssl.2:MPAC@0
odf file: ODF/MO63400766_01_160_901_adjustment-instructions.txt
dpf status domo block[1] = under_development
ODF FILE IS NOT VALID FOR THIS LOCATION

You're on your own now mate. 

[bench warmer]

Maybe the answer is in here:

ftp://reports.stanford.edu/pub/cstr/reports/cs/tr/72/258/CS-TR-72-258.pdf

or here:
https://www.freepatentsonline.com/4934507.html

Maybe not.